End feed

Feed at the end of a track with 50cm open cable. Is required, among other things, when using the Oligo system transformers. We offer the end feed in two variants:

Figure on the left:
End feed with silver cable. Is recommended e.g. when using white tracks.

Illustration right:
End feed with black, very flexible cable. Recommended e.g. when using black tracks and wherever the supply cable is not visible. Due to the flexible cable easier installation also inside a transformer.

Are you planning a rail run where a coupling is used to realize 90° corners? Then you must pay attention to the position of the positive conductor, which must be either outside or inside, when choosing the components. The following diagram is intended to illustrate this using an arbitrarily selected rail system. The green conductor here represents the positive conductor and shows its course when the feed, T and L couplings are selected. However, if you are unsure, we will be happy to help you with your selection or check your parts list for completeness based on your sketch.

Fig.: The position of the positive conductor on an exemplary rail run

Order numbers of the manufacturer Oligo:
23-512-10-06 End feed, plus conductor left, chrome matt
23-512-10-21 End feed, plus conductor left, white matt
23-512-10-23 End feed, plus-conductor left, black matt

23-512-20-06 End feed, plus conductor right, chrome matt
23-512-20-21 End feed, plus conductor right, white matt
23-512-20-23 End feed, plus conductor right, black matt

23-512-40-06 End feed with flex cable, plus conductor left, chrome matt
23-512-40-21 End feed with flex cable, plus conductor left, white matt
23-512-40-23 End feed with flex cable, plus conductor left, black matt

23-512-50-06 End feed with flex cable, plus conductor right, chrome matt
23-512-50-21 End feed with flex cable, plus conductor right, white matt
23-512-50-23 End feed with flex cable, plus conductor right, black matt