Electronic switch ELS1

The electronic switch is intended for lighting purposes only. It can be operated in all classic circuit variants, such as out-, cross- or cross-circuit and in circuits with impulse relay. By means of the ELS1, the existing circuit is extended by a switching function. Thus, an independent operation of two lights or circuits is possible, which could otherwise be realized only with considerably more effort. Due to the minimum dimensions, the installation may be e.g. in junction boxes, canopies, etc. be made.

The ELS1 is suitable for ohmic loads (incandescent lamps, high-voltage halogen lamps), energy-saving lamps, LED lamps with associated driver, low-voltage halogen lamps with associated driver, fluorescent lamps with electronic ballast (ECG) and fluorescent lamps in inductive circuit or inductively compensated circuit. When using switches with orientation light (glow lamp) in combination with energy saving lamps, the use is excluded.

Technical specifications:

Power supply: 220-240V
Maximum total current: 10A
Weight: 22g
Cable cross-section (solid wire): max. 1.5mm2
Protection class: IP20
Self-consumption (only when switched on): <0.5W

The electronic switch can be operated in three variants that cover different needs:

Circuit variants

Circuit type: add on

When the switch is closed, the light A is switched on. Light B remains off. By pressing the switch again (switching off and on again within 1-2s), the light A remains switched on and light B is switched on at the same time.

By pressing the switch again (off / on within 1-2s), the light B is switched off again. Light A remains on. If the switch remains switched off for more than 2 seconds, the ELS1 returns to its initial state. When switched on again, then switching state 1, as shown in the table, before.

Circuit type: switch off

When the switch is closed, the light A is switched on. Light B is also on. By pressing the switch again (switching off and on again within 1-2s), the light A remains switched on and light B is switched off at the same time.

By pressing the switch again (off / on within 1-2s), the light B is switched on again. Light A remains on. If the switch remains switched off for more than 2 seconds, the ELS1 returns to its initial state. When switched on again, then switching state 1, as shown in the table, before.

Circuit type: change

When the switch is closed, the light B is switched on. Light A remains off. By pressing the switch again (switching it off and on again within 1-2s), the light B is switched off and light A is switched on at the same time.

By pressing the switch again (off / on within 1-2s), the light A is switched off again. Light B is switched on. If the switch remains switched off for more than 2 seconds, the ELS1 returns to its initial state. When switched on again, then switching state 1, as shown in the table, before.